5 Ways to Save Water in the Bathroom
Bathrooms are probably the biggest source of water usage in your home. This means that they are also the biggest source of waste. Clean water is soon to become the most valuable natural resource and it might be a good time to make the necessary changes in your bathroom in order to conserve more of it.
These changes can be introduced gradually and don’t have to hurt your budget at all. The technology behind them is only going to improve and become less expensive.
The first and the simplest way to save water in your bathroom is to take showers instead of baths. It’s less wasteful to shower three times than to fill the bathtub. By choosing a good shower with a powerful showerhead, you can make showers equally enjoyable as a bath.
There are also a few details to think about when choosing a shower. For instance, if you’ve bought your showerhead before 1993, replace it and just the change in design will cut down on the waste.
Quite a significant amount of water is wasted on your sink. Turning the water on and off takes a while and during that time the water is wasted. It’s also difficult to turn the faucet off while your hands are full (when you’re brushing your teeth, for instance). The best way to fix this is to use sensor-activated faucets.
It’s a simple mechanism and it allows you to turn the water on and off in a matter of seconds and even while you’re busy. These faucets are a bit pricier, but you don’t have to change them all at once. Start with the ones you’re using the most.
A toilet is responsible for 26 percent of all the water usage in your home. That means that you should pay special attention to it and choose it based on how much water it can save you. The number you’re looking for is the number of gallons per flush.
Older models used to spend as much as 7 gallons per flush and now you can cut that in half, especially if you’re living in a country that has problems with droughts, such as Australia. Have in mind that installing a new toilet requires you to cut the water for the whole bathroom. A professional plumber from Melbourne could set it up in an hour.
The biggest problem you can have is a pipe bursting and flooding the bathroom. This will cost you quite a lot in terms of fixing it and in terms of wasting water. However, there are ways in which pipes could be damaged before it comes to this. Small leaks and bad pipes can cost you gallons of water every year.
Fixing this isn’t as hard as it seems, all it takes is inspecting the pipes at least once a year, but definitely after a harsh winter because that’s what hurts pipes the most.
Your own behavior
In the end, the way you use the bathroom and the way you treat your water supply has the biggest effect on how much you’re wasting. Make a conscious effort to modify your behavior with water conservation in mind.
You can start with turning off the faucets while you’re brushing your teeth or shaving. This alone will save gallons of water in the long run and it’s something you can easily get used to. Put a post-it-note on the mirror if you tend to forget.
Water conservation should be your main concern when it comes to bathroom design and use. Don’t forget that every little bit helps and make the changes gradually.